What Are The Reasons For The Bearing Damage Of The Reducer?
1. The bearing cavity is not cleaned or the grease added is not clean. For example, the tiny rigid material in the bearing cage is not completely cleaned up, and the bearing raceway is damaged during operation, causing excessive temperature rise to burn the bearing. Solution The gearbox cleaning and maintenance machine uses the original lubricating oil of the gearbox to clean the gearbox without adding any cleaning agent, which will not cause secondary pollution to the gear; the filtered oil can also be used again in low-end occasions to achieve Resource reuse.
2.Due to the excessively high operating temperature of the motor body and the lack of oil in the bearing and the lack of grease in the bearing in time, the bearing may even be burned.
3. Improper assembly of the bearing, such as unevenly knocking the inner ring of the bearing during cold assembly to cause the shaft to wear out, causing the inner ring of the bearing and the bearing to lose or reduce the amount of interference, and the phenomenon of running the inner ring occurs. When installing the motor end cover Uneven percussion results in a loose fit between the end cover bearing chamber and the outer ring of the bearing, causing the outer ring to run away. Either running the inner ring or the outer ring will cause the bearing’s operating temperature to rise sharply and cause burnout, especially the failure of the inner ring will cause severe wear and bending of the rotating shaft. However, under normal circumstances, intermittent running of the outer ring will not cause the bearing temperature to rise sharply. As long as the bearing is intact, the phenomenon of intermittent running of the outer ring is allowed.
4. Due to the axial misalignment of the stator and rotor cores or the insufficient precision after re-machining the rotating shaft, the inner and outer rings of the bearing are not on the same cutting surface, which causes the temperature of the bearing to increase after it runs “unusually” until it burns.
5. Replace the bearing again. After the motor end cover is nested, the interference is too large or the ovality exceeds the standard, which causes the bearing ball clearance to be too small or uneven, which causes the friction to increase during the bearing operation, and the temperature rises sharply until it burns.
6. The bearing is damaged due to the mixed use of different types of grease.
7.The standby machine has not been operated for a long time, the grease has deteriorated, the bearing has rusted and has not been overhauled.
CAMEL Transmission Machinery Factory is a professional supplier,distributor and manufacturer of speed reducers and related accesories. including gear reducers,rotary reducer,worm gearbox, servo-gearbox, planetary gearboxes,planetary gear reducer helical gear reducers,planetary gearbox,right angle gear reducer,gear reduction,gear motors, electrical motors,DC motors, DC gear motor,dc gearedmotors,AC gear motor,AC motors, servo motors,ac servo motor,dc servo motor,servomotor, bearings, gears,spur gear,helical gear,bevel gear,worm gear,planetary gear, couplings, oil seals, belts, chains, etc.If you have any need,please feel free to contact CAMEL:
sales@gear-reducer-worm.com
https://www.gear-reducer-worm.com